caspages.blogg.se - Inventor cam ultimate

Added support for toolpaths containing circles in Engrave.

Fixed an issue in which zig-zag ramping was applied in open slots when not needed.

Fixed possible zig-zag cutting paths which don't obey climb/conventional in Ramp strategy.

Fixed an issue that could cause a crash when using "Trimmed" or "Fail on collision" for "Shaft & Holder" in Pencil.

Fixed some issues that could cause crashes in some circumstances in 2D Profile.

Fixed an issue that caused Chamfer 2D to sometimes fail to generate passes.

Fixed an issue in which an incorrect warning about Ramp Clearance Height was sometimes displayed for Chamfer.

Add damping for tool axis limits in Blend and Flow with a non-ball tool so that the tool will decelerate gradually to a stop.

Fixed an issue that could cause a crash in Blend and Flow strategies.

Added support for machining boundaries and contact boundaries to Blend.

Fixed an issue that could cause a crash in linking for Blend, Flow and Multi-axis contour.

Fixed an issue that could cause a crash with some special geometry cases in Blend.

Fixed the cutting direction for paths in Blend so that it is always consistent with direction shown in the user interface.

Fixed an issue that could cause a gouge in some cases when linking for Pocket3D.Fixed an issue that could cause a crash in Pocket2D for some input contours containing only a single point.Fixed an issue that could cause a gouge in rare circumstances in Pocket2D with enabled smoothing.Fixed an issue where the ordering of passes could be incorrect in Contour2D, Pocket2D and Pocket3D.Fixed issues that could cause incorrect toolpaths in some circumstances when linking for Contour2D, Pocket2D and Pocket3D.

Fixed an issue in which offsets could be missing in Contour2D and Pocket2D when the input contours contain arcs.Fixed an issue in which incorrect tiny helical pieces in linking ramps could be produced for Contour2D and Pocket2D.Fixed an issue in which certain small parameter changes could cause a crash in Contour2D and Pocket2D.(#39134)Ĭhanges for Milling: Pockets and Contours Fixed an issue in which some localized strings with apostrophes caused bold formatting in tooltips to be lost.Generate an error if a machine is passed to the postprocessor for an unsupported packaged post.Fixed a crash that could occur when starting simulation in an empty document.Fixed a performance problem when loading HSMLib format tool libraries.Fixed an issue in which the application could crash when right clicking on a setup.Installation WHAT’S NEW The following changes have been made in the current update (2023.2): This document covers these Inventor CAM products: Autodesk® Inventor CAM™ 2023.2 Release Notes